Ford Power Stroke Nation banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2,438 Posts
Discussion Starter #1
Working on getting a set of heads (valve job and springs) I do not want to pull the motor to install studs (do not want to pull the motor) so can I reuse my bolts or should I get new ones, and are there good aftermarket ones out there? Do they have to be re-tightened and if so when.
 

·
Premium Member
Joined
·
3,060 Posts
I would not recommend reusing stock bolts...

even though they are not TTY (torque to yield)...there are some fasteners on an engine (especially one putting out nearly double stock hp)...than I would recommend.

I can ship new OEM Ford bolts out tomorrow, or a set of H11 headstuds...
 
1 - 3 of 3 Posts
Top