Ford Power Stroke Nation banner

1 - 7 of 7 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
Howdy all

I have installed a triple disc torque convertor in my '01 F250 SD 7.3 with the 4R100. The problem that I am experiencing is that after it warms up in drive it sounds like someone is throughing gravel up at the bottom of the floor board. Could this be that the convertor has trown a spring or someother part or does it sound like the flexplate is broken? It has me stumped and would greatly appreciate any input.

Thanks
 

·
Registered
Joined
·
4,042 Posts
If it was the flex plate I would ASSUME it would do it warm or cold
 

·
Registered
Joined
·
10 Posts
Discussion Starter #3
Thanks for all the help but I just got done ordering a Banks Torque Convertor, ATS Stage 2 Trans., New Flexplate. I'm getting ready to order a Banks Transcommand and an Edge Evolution(and get rid of the Bully Dog 4 Band 6 Posistion chip). So if you or anyone you know is interested in the chip I'll let it go for $240.00
 

·
Davey B
Joined
·
930 Posts
The edge chips have been known to eat the trans on these trucks. It would be cheaper and you'd be alot happier by going with a custom burned chip by one of the vendors on here. With the custom tunes you wouldnt need the banks trans command.
 

·
riverjet
Joined
·
459 Posts
PLEASE don't waist your money on the Banks trans command! I messed with Banks,Edge,sct,Hypertech.Their all pure garbage.Your truck will run so nice with a good tuner.
 

·
Registered
Joined
·
666 Posts
Thanks for all the help but I just got done ordering a Banks Torque Convertor, ATS Stage 2 Trans., New Flexplate. I'm getting ready to order a Banks Transcommand and an Edge Evolution(and get rid of the Bully Dog 4 Band 6 Posistion chip). So if you or anyone you know is interested in the chip I'll let it go for $240.00
i see your new here but i wish you would have looked into a bts transmission, im not sure what you paid for the other but to late anyway. you should definetly look into some custom tunes, i run gearhead but there are a few good ones on this site.
 

·
What else?
Joined
·
4,156 Posts
Thanks for all the help but I just got done ordering a Banks Torque Convertor, ATS Stage 2 Trans., New Flexplate. I'm getting ready to order a Banks Transcommand and an Edge Evolution(and get rid of the Bully Dog 4 Band 6 Posistion chip). So if you or anyone you know is interested in the chip I'll let it go for $240.00
To be honest, I would send all those parts back, I wouldn't recommend any of them to a friend, or you.

I would check your converter nuts to be sure they're tight. And what brand of converter is it? Also, does it make the noise with the converter locked or unlocked?

Dave
 
1 - 7 of 7 Posts
Top