Ford Power Stroke Nation banner

1 - 3 of 3 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter #1
I have a 2004 F250 XL and want to install some nice looking aftermarket headlights. I of course have the sealed beams, and most of the headlights I have found online say they are not for sealed beam models. Ultimately, I would love to have these lights on my truck Anzo USA 111106 - Shop RealTruck.com but I have seen these lights on some sites along with the "not for sealed beam models" warning. I have tried to do the research to figure out if they are not the right shape to fit into the truck, or if they just need to be wired up differently, but can't seem to find a straight answer. Can anyone tell me if I can run these lights and what I would have to do to make them work? Thanks!
 

·
Registered
Joined
·
122 Posts
The only problem I can see is that you are going from a 2 part headlight to a 1 piece headlight which will probly result in needing to trim parts off the header panel
 

·
Registered
Joined
·
23 Posts
Discussion Starter #3
I don't mind if I have to do a little trimming to get the look, that shouldn't be too much of a problem.
 
1 - 3 of 3 Posts
Top