Ford Power Stroke Nation banner

1 - 6 of 6 Posts

·
Registered
Joined
·
109 Posts
Discussion Starter #1
I have been searching to find out if anybody has successfully hooked up the OEM power fold/telescoping switches in there pre 2008 truck? I have seen several get the functions working using after market switches but have not seen any using the OEM switches. I will be installing 2009 FX4 door panels in my 02 F350 and I want to try and use all the OEM switches. I found info for getting the new power window switches to work but lacking the door lock and power mirrors.
 

·
Registered
Joined
·
109 Posts
Discussion Starter #2
I got all my wiring ran last night and have the turn signals and marker lights hooked up and working. My old towing mirrors did not have signals and were pretty basic so I had to run new wire for the new features. Unless somebody chimes in with some info on using the OEM switches, I will just wait on my door panels and try to hook everything up when they come in this week. I think I have everything figured out but the power door locks. I still can't find a pinout and wiring diagram for the new 2009 door lock switches. I was told by someone on another forum that because of the SJB they would not work as it supposedly controls voltage sent to the switch but I don't want to believe that. Here are a few pics of my mirrors installed.

Old Mirrors


And it begins
(pretty lame Saturday night :eek:)








New wire I ran for the additional features



Tapping in for signals


And then there was LIGHT


Bath timeLOL






I am really liking these new mirrors. They work so much better than my old ones:redspotdance:
 

·
Registered
Joined
·
126 Posts
I got all my wiring ran last night and have the turn signals and marker lights hooked up and working. My old towing mirrors did not have signals and were pretty basic so I had to run new wire for the new features. Unless somebody chimes in with some info on using the OEM switches, I will just wait on my door panels and try to hook everything up when they come in this week. I think I have everything figured out but the power door locks. I still can't find a pinout and wiring diagram for the new 2009 door lock switches. I was told by someone on another forum that because of the SJB they would not work as it supposedly controls voltage sent to the switch but I don't want to believe that. Here are a few pics of my mirrors installed.

Old Mirrors


And it begins
(pretty lame Saturday night :eek:)








New wire I ran for the additional features



Tapping in for signals


And then there was LIGHT


Bath timeLOL






I am really liking these new mirrors. They work so much better than my old ones:redspotdance:

You can use oem switches.....no problems
 

·
Registered
Joined
·
109 Posts
Discussion Starter #4
You can use oem switches.....no problems
Have you done it? How did you wire up the power lock switches? Do you have a pin out and/or wiring diagram
 

·
Village Idiot
Joined
·
8,209 Posts
Lucky horseshoe?
 

·
Registered
Joined
·
109 Posts
Discussion Starter #6
Lucky horseshoe?
Ha I am hoping so. I found it in November on a mountain top in New Mexico. But then again I missed my Mule Deer so maybe not so luckyLOL
 
1 - 6 of 6 Posts
Top