Ford Power Stroke Nation banner

1 - 7 of 7 Posts

·
Registered
Joined
·
137 Posts
Discussion Starter #1
Subs and amp worked fine last night. I started the truck and let it run this morning it was running for about a half hour then I got out to it and noting still have green light but not getting power to subs any I ideas??
 

·
needs more fuel
Joined
·
697 Posts
sounds like a channel on your amp went out. if its a multi channel amp, try swapping the rca's and speaker wires to a different channel.
 

·
Registered
Joined
·
137 Posts
Discussion Starter #4
Well I have a remote gain knob that's not lighting up now. But I'm still showing green light so if it was blown would it still show green
 

·
needs more fuel
Joined
·
697 Posts
if a channel goes out then yes it will still show green. if the whole amp is fuked then it will most of the time it will show red (protect mode)
 

·
Registered
Joined
·
137 Posts
Discussion Starter #6
Ok. It's a two channel amp. So take the RCA cables and move them over
 

·
needs more fuel
Joined
·
697 Posts
yes, youll have to move the speakers wires over to the channel you move the rcas to.
 
1 - 7 of 7 Posts
Top