Ford Power Stroke Nation banner

1 - 5 of 5 Posts

·
Registered
Joined
·
144 Posts
Discussion Starter #1
I have a built 99 7.3 and the oil pan gasket is leaking and the dipstick is leaking where it enters the block. Can you get the oil pan off to get a new gasket in there without taking the motor out??? Please help!!!
 

·
Your Daddy
Joined
·
198 Posts
No.

Well there was this one guy that cut out his crossmember and rewelded it back in...
 

·
STILL LEARNING
Joined
·
18,324 Posts
I have a built 99 7.3 and the oil pan gasket is leaking and the dipstick is leaking where it enters the block. Can you get the oil pan off to get a new gasket in there without taking the motor out??? Please help!!!
You will need to do this:eek:
 

·
Registered
Joined
·
2,206 Posts
We have done several of these jobs and always pull the motor. It's such a hassle for that job but it's the best way to get it done right.


Sent from Holderdown Performance mobile command center
 

·
welder/fabricator
Joined
·
30 Posts
the local ford gurus up here jack the cab 6" then pull the motor up on and angle and then replace the pan and evrything, you dont have to believe me but i watched them do it this way in under 6.5 hours
 
1 - 5 of 5 Posts
Top