Ford Power Stroke Nation banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hi Peeps, Newb here. I have a problem trying to scan for trou sble codes. I'm using a "AutoXray EZ Link" OBDI & II scanner. When using the Key On Engine Running (KOER) scan, the scanner acknowledges starting the scan sequence, then proceed what I believe is the first scan starting with the "MIL ON/OFF" light. As soon as it displays "MIL ON" the truck shuts down. Physically have to restart the engine again. Scan seems to stop at that display. At the first ignition key position......the MIL Light aka:(Check Engine Light) does come on with others like battery etc. but immediately shut off when engine running. I just can't figure out why I can't get a complete OBDII scan out of this without engine being forced to shut off.

Any help is greatly appreciated.....I'm stumped.

Regards,
Zipwax
 

·
OBS Addict
Joined
·
1,538 Posts
welcome to PSN.

but you shouldnt ahve posted this here instead shoulda posted in the OBS section. youd prolly have tons of answers by now lol.

as for your problem i cant help ya. im not good with scan tools.
 

·
OBS Addict
Joined
·
1,538 Posts
It's a super easy site to navigate...just look around.
 
1 - 4 of 4 Posts
Top