[ncstroker]

I Just had injectors replaced, and I think it got to like 40 degrees last night, well when I went to crank it this morning it turned over fine, smoked like crazy and would never hit on anything, just kept turning over and smoking real bad. what do i do?

 

[POWERSTROKER]

Weak FICM seems most likely, did you have any trouble before?

 

[ncstroker]

this is the first problem I have had of this sorts since i replaced injectors, are you sure its the ficm, i dont want to buy one and that not be it

 

[6.0 p-stroke]

i had the same issue, try plugging it in and check your cps

 

[ncstroker]

plug the ficm in? and check what?

 

[Slated4Greatness]

GPR? Is it throwing any codes?

My FICM threw codes of low voltage inj 1-8.

Did you have all 8 injectors replaced? My dealer did 2 at a time and each time the truck would crank for a long time until they swapped out the next set of injectors.

 

[6.0 p-stroke]

plug in your block heater if its not starting and its cold out, i have to plug mine in if it gets in the 40s. check to make sure the cps is plugged in, wiggle the wires. Just throwing this out there, it worked in my case

 

[ncstroker]

it threw the codes injector circuit low in cyl 1-8, and FICM performance, so i guess i am in the market for a FICM now

 

[id: 5520]

it threw the codes injector circuit low in cyl 1-8, and FICM performance, so i guess i am in the market for a FICM now

You may just need to do some soldering on the board. Do a search on here..