Ford Power Stroke Nation banner

1 - 12 of 12 Posts

·
AllYourBaseAreBelongToUs
Joined
·
13,954 Posts
Discussion Starter #1
Is there a way to tell if a 6.0 trans is from a 4x4 or a 4x2? I'm gonna be getting a trans built here soon and I have one sitting here to send so I don't have to have my truck down while it's being built. But I don't know if it's out of a 4x4 or a 4x2.

Or does it even matter?

.
 

·
Don't EFN worry about it
Joined
·
15,588 Posts
Ouput shaft area is there about a 5" hole there were the t case goes??
 

·
Corona Killa
Joined
·
1,727 Posts
2wd well have a different tailshaft housing and will look complete without a
t-case.
 

·
Registered
Joined
·
1,606 Posts
It matters but you can have either one built built. Then when you get it built stand both trannys up on the bell housing. Then pull the output section off one and swap it to the other one. I have done it.
 

·
AllYourBaseAreBelongToUs
Joined
·
13,954 Posts
Discussion Starter #6
By y'alls description sounds like I have the 4wd. :rockwoot:

Here's some pics just to verify:








 

·
Registered
Joined
·
1,606 Posts
Yes, that is a 4wd.
 

·
Registered
Joined
·
597 Posts
Where are you sending it Danny?
 

·
AllYourBaseAreBelongToUs
Joined
·
13,954 Posts
Discussion Starter #12
David at Diesel Innovations.
 
1 - 12 of 12 Posts
Top