Ford Power Stroke Nation banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a 2011 f250 with fabtech 4 link 8" suspensin with 24" wheels and 37 tires. With fatocry one piece drive shaft. Installed the blocks that fabtech gave me with the taper end forward. Had bad vibration. So extend drive shaft still has vibration. Installed some 8" blocks with no taper. Still has vibration from 45 and 65 was going to install two piece drive shaft from high angle driveshaft. Brought it to shop for the them to install driveshaft they said it not my driveshaft. They said it my vibration damper r bent axle. I still think it my pinion angle and i need to install the Two piece drive shaft. Can anybody help me. I have 7000 miles on truck and since lifted it its been have vibration
 

·
Registered
Joined
·
3,432 Posts
It may be the pinion angle, you got any pictures of the setup? Seems like a one piece driveshaft would have been fine.

Have you had your tires checked out?
 
1 - 2 of 2 Posts
Top