Ford Power Stroke Nation banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Please help!! I replaced my factory body mounts with S&B body mounts but now that it’s done my passenger side cab sits about 3/8” higher than the bed body line. There is no rust on my truck anywhere since it’s a California truck, can anyone help me figure out what’s wrong? The truck has never been wrecked and lined up fine on the factory mounts.
 

·
Administrator
Joined
·
13,822 Posts
S&B is some quality stuff
you can measure from the floor pan to the mounting tab on each side of the frame to verify the equal distances

if yjr body mounts are all equal and it was my truck I would address this at the bed with shims
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
S&B is some quality stuff
you can measure from the floor pan to the mounting tab on each side of the frame to verify the equal distances

if yjr body mounts are all equal and it was my truck I would address this at the bed with shims
What if the cab is misaligned front to rear not side to side? Also, is there anything the can could possibly be pinching between its self and the frame or is that not a thing?
 
1 - 3 of 3 Posts
Top