Ford Power Stroke Nation banner

1 - 2 of 2 Posts

·
Banning Smut
Joined
·
19,093 Posts
Discussion Starter #1
OK. I might run 35s instead of 33s. I would like to do it without having change a whole lot of suspension parts since I was able to get all the stock stuff to go back on my truck. My thought is to run a DR mini spring pack with a warrior shackle. Could I get away with running factory pitman arm and trackbar? I do have an adjustable fabtech trackbar I could use if I had to.

On the rear...thinkin' just a 5" block. Will i need to retain my carrier drop?
 

·
<- Sums it up
Joined
·
1,739 Posts
I would use 4" lift springs. But that is me.

35"'s rubbed the running boards and the fender liners, I was told that because of the 475lb bumper on the front of my truck. So I had to shift them back 3/4" of an inch. Plus I had to cut off a steel tab where two sheets of steel come together with a bolt, behind the fender liners. Then zip tie the fender liner, tight against the truck, to the body mount. Now I have little rub only when I don't turn hard and hit a big bump.
 
1 - 2 of 2 Posts
Top