Ford Power Stroke Nation banner

1 - 20 of 20 Posts

·
<<< THE GAUGE WHORE...
Joined
·
12,082 Posts
Discussion Starter #1
Anyone remember what might be behind here? I have a Isspro temp sender I want to drill and tap where the X is... is there any clearance issues there?



:(
 

Attachments

·
A Ghost these days.
Joined
·
1,017 Posts
I'd say pull the cover and take a look. There should be some room all around but I'd pull it to drill and tap it that way no derbies get into the diff. Just me though.
 

·
Registered
Joined
·
17 Posts
I think the caps of the carrier bearings are right there. Been a while since I did mine.
 

·
Registered
Joined
·
17 Posts

·
<-- GO BRONCOS
Joined
·
965 Posts

·
Registered
Joined
·
629 Posts
Looks good to me and it's low enough to be in the grease to get a good reading. I did my cover about two weeks ago.
 

·
<<< THE GAUGE WHORE...
Joined
·
12,082 Posts
Discussion Starter #8
Thanks DC, thats all I needed to see, I will drill and tap where I marked. Thought about painting the thing or polishing but screw it... the crap they spray on the roads eats every thing anyway...
 

·
Registered
Joined
·
17 Posts

Lets hope the powder coating holds up!
 

·
Custom Trailer Sales
Joined
·
6,161 Posts
Looks good!!
I need to do mine to
 

·
Registered
Joined
·
17 Posts
Exactly. Used a file in the tight spots. I figured i could file the fins each year just to brighten up the aluminium
 

·
Registered
Joined
·
629 Posts
I went to ACE Hardware and bought 5/16 by 1 1/4 inch long with a stainless
washer to match...$6 I believe. Auto Zone for the Ultra Gray silicone and Grease... Good luke and you'll like it more when it's on your truck>>
 

·
Custom Trailer Sales
Joined
·
6,161 Posts
Where's the cover at powerstrokeshop, for the Dana 80's??
 
1 - 20 of 20 Posts
Top