Search Results for ‘help asap’

Hello all, having some troubles with my 6.4 after I replaced cylinder 6 injector. Had air in fuel(best guess) and wouldn’t stay started and kept dying. Pissed me off while at a red light and died. Now it hasn’t died after I ran it awhile and kept bleeding the line, but it threw a p0266 for...

I was driving everything was fine, pulled over to take a call went to start it up again, and it entered limp mode. I replaced the icp sensor, inspected the ipr valve it was good, did a air test, no air leaking, replaced oil filter did an oil change and now scanner is reading no ficm sync, and no...

Does anyone know what size tap i need to re thread the bolt hole in the end of the crankshaft where the lpop and hb go? I stripped some of the threads trying to reinstall the balancer so i bought a new bolt but i still need to chase the threads please any help is appreciated!

04 6.0 CCSB King Ranch, went down last week because of a P0674 and 676 code. It also popped the GPCM code prior to that, so I changed the Module and all the driver’s side glow plugs. Now, the truck for some reason is still popping the singular 674 code and I cannot figure the issue out. Symptoms...

I have a 1999 F350 7.3 with a zf6 manual transmission. Backstory is we bought it after it had been sitting for 8+ years For almost 2 years now we have been trying to diagnose this specific problem where you randomly get loss of power. Its also not a complete loss of power, before replacing EBPS...

Bought a 95 7.3 Powerstroke that has had GPR going out weekly. Had put a new one on there from eBay kit Ford diesel glow plug relay Manual controller-solenoid | eBay Having crazy sparking from battery terminals when getting a jump or taking off/on the battery terminals on the battery. Truck...

I’m working on a 2006 F350 with a 6.0 for someone else. I haven’t worked on the 6.0s before but I have a ton of experience with the 7.3s. Now for the details. History: (from what I was told) Truck has 268k Cranks but doesn’t even try to start I was told that the truck was running fine then just...

Hi guys, first post here. I have a 2005 F250 with the 6.0 powerstroke. Truck is loosing coolant at a fast rate with no visible leak even after pressure test. White smoke only on initial acceleration during cold start. Replaced oil cooler with OEM oil cooler and gaskets less than 1k miles ago...

Welp bought a 6.0 it’s zf6 trans I am having a issue when if the truck sits for a good amount of time and I go to start the truck I’ll let it warm up for about 5 min before leaving for work, I’ll hop in the truck go to drive off and it acts like it’s got a miss or air in the fuel system kinda...

I have a 04 f350. I was driving it and it was driving normal but when I turned it off and took the key out of the ignition everything just off except the motor. Yes, ignition in off position and key is out. Rpm, milage, gas and all other guages powered down but engine continues to run. Started...

Ok so here is the problem, truck blew head gaskets changed them and studded it ok no big deal. Now is where the fun begins we go to fire it back up and it isn't getting oil to the top end so i throw a new lpop and cover on it, ok now we get oil to the top but there is still no pressure. And all...

About 2 weeks ago I had rolled my 02 7.3 zf6 bought a 2wd v10 roller to swap front clip and cab and went to start the truck today truck started shut it off after it started checked oil was dry then put oil in the truck now won’t start would like to make sure my engines fine before starting the...