Ford Power Stroke Nation banner

just did my own ccv mod wondering if its correct

881 views 4 replies 5 participants last post by  Extended Power 
#1 ·
hello all i just did my own ccv myself cost 10 bucks i just cut all of the old tubing off the 90 deg ccv elbo that goes in the cc itself and put 1 in heater hose on it and went strait down to the outside of frame rail and ziptied it to the bumper mount because i read the least amount of hose the better and i used a electrical box round cover and some rtv black gasket maker to seal the hole in cai tube is that alright or should i change it? thank you all
 
#3 ·
You'll probably be ok with that. I used JB weld and some thin cardboard (like off of a toilet paper roll) to plug the hole. It isnt really subjected to any pressure so I am sure you will be ok.
 
#4 ·
Sounds good to me.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top