Was running fine, shut off now no start
So I took the truck out last night and it was running fine and died and now won't start. I recently rebuilt the engine from the ground up and the truck has been running phenomal until last night. It'll crank but won't fire. All the injectors have been re-oringed I changed the ipr
while the motor was out it has a relatively new cps
and I converted to electric fuel running 70 psi
at idle and now when I kick the fuel pump on to prime it's reading 95 and the regulator has not been turned up or moved since I've been running it. I have a hpop
gauge from glow shift and the when the truck was running it would fluctuate ever so slightly at idle from about 450psi to 400psi or so and I never paid attention to it because it ran great. Over the time I've had the truck I've changed the icp
sensor 2 times and each time they went bad the truck would run terribly but would start no problem and right now I'm at a loss for what it could be that's not letting the truck fire, any help is appreciated. Could the ipr
make the fuel pressure go up with out the motor running?