Hey, looking to put a 96 7.3 diesel into my 2 seat offroad buggy on 42's im designing
Im getting a 7.3 with the engine harness tomorrow
I know I need the PCM
, ICM, TCM and accelerator pedal, and am looking for a donor vehical to rip the parts from.
My only question is, can i run aftermarket Autometer gauges(tach, Speedo,ect)
Would they be electrical and tap into the PCM
for the sensors?
Im looking to use a 4r100
trans behind the 7.3, and i know that with the e40d, the VSS/ABS sensor is on the rear axle, but my axle (dana 70) doesnt support a toner gear or VSS
Is anyone using the VSS
ports/ Speed sensors on the 4r100
for the speed sensor output to the PCM
How is that done?
Im not running ABS
, but dont want my trans to shift like crap, with no tach or speedo though