Whats the steps to program a key fob on a 96 f250 slt? i have power everything, just picked up a fob and the instructions I have read this:
"1. Turn ignition to RUN or ACC
2. Momentarily jump pins in programming connector located at the base of the steering
column. All doors will lock then unlock to confirm programming mode.
3. Press any button on first keyless remote. Door locks will cycle to confirm programming.
4. If programming a second keyless remote, press any button on second keyless remote.
Door locks will cycle to confirm programming.
5. Turn igniton to OFF. Locks will again cycle to indicate end of programming mode."
But step 2, I don't see where the connector is at steering column base to jump.