Ford Power Stroke Nation banner

gauge install???

937 views 3 replies 4 participants last post by  94strokeher 
#1 ·
I have a 96 with a 7.3 and e4od. I'm lookin to install a boost,tranny temp,and exshaust temp gauge. Can anybody tell me the best places to install each guage for the best reading. Thanks for any and all input.
 
#3 ·
Boost in the Y pipe remove it then drill and tap, pyro in the collector or a manifold, same goes here. Trans temP into one of the pressure test ports, easiest one is right above the front driverside corner of the pan, simple remove the plug and insert your temp sender
 
#4 ·
I put my Pyro in the drivers side manifold, And my boost i taped into the map line with T fitting.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top