Ford Power Stroke Nation banner

truck just quit

1K views 9 replies 4 participants last post by  countryboyrob 
#1 ·
the truck quit and it wont start again the check engine light comes and there was some oil on the front of the motor toward the bottom side like it blow something so any ideas thanks
 
#5 ·
well it was my truck and i sold to a friend of mine and when he said there was oil on the ground i thought right away of the high pressure oil lines but when i got there the oil spot was only bout 4 inch circle and thats the only oil i seen and it was coming from somewhere on the lower part of the motor below the water pump somewhere but i couldnt make out for sure where it came from and i did pull some codes on it to is there someone on here that could tell me what they mean p0528 p0603 p0683 p1000 p0706 p0707
 
#6 ·
Are you typing this from your phone?

I just googled these codes.

p0528-fan speed sensor
p0603-KAM error-keep alive memory
p0683-Glow plug diagnostic signal communication fault Circuit/connector failure, failed GPCM, PCM
p1000-OBD drive cycle not complete
p0706-Transmission Range Sensor Circuit Range/Performance
p0707-Transmission Range Sensor Circuit Low Input
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top