Ford Power Stroke Nation banner

questions on instaling lift

742 views 5 replies 3 participants last post by  07_powerstroke 
#1 ·
i have purchased a 8in basic fabtec lift will i need any special tools i bought a pitman arm puller already... and i bought dual steering stabilizers will i leave the stock one in place? it didnt really say in the instructions..
 
#4 ·
Don't need a pickle fork. You can use the pitman arm puller (which most likely will need the latching tabs to be ground off a bit to make it fit ove the pitman arm) on the tierod ends if the hammer trick doesn't work. Pickle forks will damage the rubber boots on the tierod ends.
 
#6 ·
my pit man arm is too small i need to get a dif one. and i hit the arm that goes to the pit man arm and i cant get it loose... i did soak everything in pb blaster weeks before i started lol.. i also need to get new alinment pins for the rear springs.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top