Ford Power Stroke Nation banner

Oil PSI Gauge setup

663 views 2 replies 2 participants last post by  Myles_S 
#1 ·
Wheres the best port to use for Oil press gauge? What size fitting is it? Ill have to pick up a threaded plug so i can mate the plug on my guage up to it.

What are normal readings?
Idle..?
Hwy speeds...?
How low/high can it go before causing damage?

Thanks in advance
 
#2 ·
there is port on the filter housing and on the same side as the filter i used a port thats right on the lip of the bell housing where the trans and motor mate..if i remember right my sendor that came with the auto meter went right in...

when up to temp i read 25 at idle and 40 under load.... they will read higher on a cold motor..
 
#3 ·
My gauges were a old set i had rolling around in the bottom of my dresser. Got a few pieces missing.

Thanks
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top