Ford Power Stroke Nation banner

How Do you get the smaller profile valance for the 08-10

2K views 17 replies 4 participants last post by  sunrisefordparts 
#1 ·
I have seen some pics of the smaller profile valance on some of the 08-10 trucks,were can i get one?
 
#3 ·
:D Thanks
 
#4 ·
Job 1 and Job2 builds had different valance (air dam) heights on both the 05+ front ends and the 08+ front ends.
 
#6 ·
Well i used your vin Dustin and They sent me over the big one again...fords trying to tell me thats what is on a 2008 :doh:
 
#7 ·
wtf... i hope they didnt update that part number so all of the trucks have it, i was going to just remove it all the way and bend the sheet metal up to clean it up a bit.

Sorry phil i thought for sure they would get you the right one. You might talk to them and see if they can tell if its been updated part number.
 
#8 ·
Ya I will try that thanks dustin...Just sell me yours LOL
 
#10 ·
8c3z-17626-b
 
#12 ·
ok ill see what they say thank you
 
#13 ·
Well i called them they are bringing that one over and taking back this other one so will see what happens
 
#14 ·
Got one Thanks a ton guys.
 
#17 ·
Boy I guess!! :bowfast:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top