Ford Power Stroke Nation banner

billet intake plenum's

2K views 11 replies 9 participants last post by  smokyred 
#1 ·
Noticed when I took these off there is no groove like on stock plenum's for the grey rtv to ride in.Also noticed that the amount of grey rtv left was so thin didn't look like there was a good seal.

?'s

1.Putting her back together should I run gaskets?I have already cut them myself out of some high temp gasket material.

2.Or run gasket+grey rtv on all mating surfaces?

3.Or run just grey rtv again?

4.Suggestions?
 
#3 ·
I know ford makes a product specifically for that application. Or just use black rtv like me. :D
 
#7 ·
Just good old gray or black... let it set for a few minutes and TQ to spec
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top