Ford Power Stroke Nation banner

Engine stand help

2K views 4 replies 3 participants last post by  whytry 
#1 ·
I have an engine stand and a 2001 7.3 and I was wondering if anyone knew what size bolt I need to put it on the engine stand
 
#4 ·
Are you talking about the bolts that hold the motor where the tranny bolts to?

I can give you the metric size but the length will be determined by your stand. Also, I have used tranny bolts in the past when I didn't have the others when I needed them.


M12 x 1.75

I've used both 95mm and 105mm bolts depending on what all is still on the back of the engine and spacers being used.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top