Ford Power Stroke Nation banner

Changing ball joints

1K views 8 replies 5 participants last post by  jinco 
#1 ·
I need to change my ball joints. Was wondering what all had to be removed up front to get them off. You can't get a removal tool in there because of the axles. If I remove my locking hubs, brakes, rotor, etc.... Will the whole spindle/outer hub slide off over the axle and all when I break the joints loose? I've never replaced ball joints on a 4x4 before so I'm not sure what all has to be removed or what steps to take.
 
#3 ·
that's a good find right there, thanks
 
#7 ·
Worked that time. That's an awesome write up! Very straight forward.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top