Ford Power Stroke Nation banner

dtc P1000

3K views 6 replies 3 participants last post by  moose7.3IH 
#1 ·
my truck cut out on me drivin down the road and i had to pull my ts out to get it start to drive home... once i got home i put my chip back in and it showed this code... something bout manufacturers fuel air ratio... does anyone know what this is
 
#2 ·
P1000 comes up when you havnt done a drive cycle. Havnt tested all your sensors. Crank it up and drive it around for a few minutes and then see what you got.
 
#3 ·
i did that and it was still cuttin out on me on the way to work today then drove it to lunch and it was fine then cleared it on my lunch break
 
#4 ·
When you say " cutting out" do you mean it dies, or stumbles? Have you checked your cps?
 
#5 ·
when i say that i mean falls flat on its face and ses and wait to start light come on and there is no throttle at all... and yes just replaced it in the fall
 
#7 ·
ok thanks alot guys
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top