Ford Power Stroke Nation banner

black factory wheels

1K views 8 replies 5 participants last post by  powerstrokin15 
#1 ·
have you ever blacked out your factory wheels? if so, how? and can I get some pics?
 
#3 ·
I did it on my ranger. Just painted them with rust resistant paint from autozone. Turned out pretty good.



 
#5 ·
Do it man. Any truck with black rims looks good.
 
#7 ·
nice. its worth it. trust me.
 
#8 ·
Just painted my front wheels today, finishing the rear wheels tomorrow. These are the steps I did:

1. washed wheels with dish soap
2. went over wheels inside and outside with 400 sand paper
3. went over wheels inside and outside with 1000 sand paper
4. washed again with dish soap again
5. let dry
6. spray with 2 coats of rust-o-lium adhesive primer
7. spray with 3 coats of black BBQ/Grill paint (or color of your choice)
8. spray with 2 coats of clear coat for wheels

If you want the flat black look then skip #8. I'll post pics when I can.
So far I've only found one run that I will take some sand paper to tomorrow and re-apply clear coat.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top