I am replacing my rear axles seals and wheel bearings and I am stuck on the re-assembly. I had the inner bearing race pressed in at a machine shop, installed the bearing and installed the axle seal. I put the hub back on as well as the inner race and bearing. When I try to re-install the special axle nut it seems like there are not enough axles threads showing for the nut to engage. Am I missing a step or is there a trick to this?
that was my next thing. If the races arent in all the way, the hub will not fit properly...
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Ford Power Stroke Nation
2.5M posts
107.4K members
Since 2007
A forum community dedicated to Ford Power Stroke owners and enthusiasts. Come join the discussion about diesel performance, modifications, EGR deletes, troubleshooting, lift kits, tires, wheels, maintenance, and more!