Ford Power Stroke Nation banner

Need 2 Know!!!!!

750 views 5 replies 4 participants last post by  halerazor 
#1 ·
Alright now I have had my gauges installed in my truck for about a month now and I am finally ready to install the senders so they really work:doh:

What did you guys use as thread sealant on your fuel pressure and oil senders. Teflon I dont believe will work but on the water and tranny sensor. Also did you use anything on the pyro???????????? :confused:
 
#5 ·
loctite makes a thread sealant that i use on oil, water, and solvent fittings. it is Loctite 567 with ptfe. its a little expensive but works the best. check to see if you have a hydraulic supply near you ( cauliflower industial etc) they carry alot of good thread lubes and sealants. also i would put a little neverseize on pyro threads.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top