Ford Power Stroke Nation banner

2008 10" Fabtech 4 link with 40x15.50R20 toyo's?

4K views 7 replies 4 participants last post by  Slowheelie 
#1 ·
I have a 2008 f250 crew cab short bed and I'm looking at the 10" fabtech lift but I really like the toyo open country mt's so I would need to go 15.50 wide and not the 13.50 that fabtech recomends. Does anybody know what I would need to do to make the 15.50's fit? My rims are driv blitz 20x10 I'm not 100% sure on the back spacing but I think it's around 4.5".
 
#3 ·
10 inches of lift you shouldn't have to worry about rubbing with a 40 inch tire at all
 
#4 ·
with 10" of lift you'll be fine but if you do anysort of tight turns especially with a 15.50 on a 20x10 you're going to run a bit...my recommendation is if you're wanting to run the 40's, bump up the lift 2" and run a 12" lift....you'll be much happier anyway.

Chad
 
#6 ·
here sis mine 10 inch fabtech with 4.0 coilovers 40 15.5 toyos fuel octane 20x12 -44 offset i just barely touch if im at full turn and hit a decent size bump otherwise no issues
 

Attachments

#7 ·
Slowwheelie....yes you can run a 2"spacer on top. It won't harm anything at all...a good recommendation would be to go to a wider wheel as well....I have run 20x9, 20x10, 22x12, 22x14and now 24x12.....your best bet is a 12 wide

Chad
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top