Ford Power Stroke Nation banner

Custom adjustable track bar anyone?

1K views 5 replies 3 participants last post by  Zmann 
#1 ·
made my 2000 a set of lift shackles that will give me about 1.5-2" lift in the front. My question is will I need a track bar and if so has any one customized the stock one. If so how did you guys do it
 
#2 ·
u can figure out how to measure your axle shift ? if not ask

but stretching a track bar can be as easy as a cut and sleeve you don't need adjustable if your just lifting it one time and done

or a whole new adjustable unit for future mods
 
#6 ·
it won't kill you to get the lift in and then measure to make sure there is an axle offset
cut the trac bar, sleeve it, then center the axle( push the body and stabilize if it doesn't just find it's own center )) and mark the ends of the sleeve and weld it up
even if you need to drive it with the axle shifted a little won't be a problem
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top