Ford Power Stroke Nation banner

Decking the heads.

1K views 6 replies 5 participants last post by  Machinist 
#1 ·
What is all required to get the heads decked on a 6.0
 
#2 ·
I think you just need to pull the injectors and glow plugs off and bring the heads to the machinist.
 
#4 ·
That would be decking the block, you asked about decking the heads lol.
 
#5 ·
Yup, that's a whole 'nother ballgame there. :D
 
#7 ·
Pretty much what has been said - strip the heads down of the rocker boxes, glow plugs, injectors, etc. They will be washed and then valve recession checked along with current warp to make sure surfacing will not put them below the safe limit. You need to make sure the machinist has quality equipment that will put on a finish acceptable for MLS gaskets, 10-20 ra is a good range to be in.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top