Ford Power Stroke Nation banner

Studding, looking for a big enough torque wrench.

1K views 5 replies 4 participants last post by  slandry786 
#1 ·
Hey, trying to stud my 6.0l. I am looking for a reasonably priced torque wrench that will go to at least 250ft/lbs, any suggestions?
 
#5 ·
Only problem with the O'Rileys torque wrench I would be leery of is the calibration of it. Maybe they have a programs where they calibrate them often? I would be worried that some guy before you used it to loosen bolts or over torque something so it is not actually toqueing to the proper torque.

Eric
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top