That was my next thought to match the stock pitch if I didnt get any answers. Is it critical on the pitch of rear axle on 6 inch blocks? So in most cases to get the stock pitch on a lifted truck the blocks would be some what tapered correct?
Yes my stock blocks are flat and I have a CCSB. I'm just wondering what I should do when I build my own blocks. If I do flat will dropping the two piece drive shaft be enough to get the right angle?
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Ford Power Stroke Nation
2.5M posts
107.3K members
Since 2007
A forum community dedicated to Ford Power Stroke owners and enthusiasts. Come join the discussion about diesel performance, modifications, EGR deletes, troubleshooting, lift kits, tires, wheels, maintenance, and more!