Ford Power Stroke Nation banner

01 f250 4x4 trac bar question

813 views 2 replies 2 participants last post by  01powerstrokin 
#1 ·
if i level my f250 4x4 and install a 2.5" leveling/lift. how much longer does it need to be? If I remember the factory trac bar is 29.5" center to center.

I was either going to cut and thread a adjustable sleeve similar to the factory drag link adjustable sleeve. that would be the best way to fine tune the front axle centered under the truck.

But What I can do without searching for parts is cut it and sleeve it to some where around 31"s.

can anyone with a adjustable trac bar measure center bolt hole to center bolt hole to give me a idea what to make this one.
 
#3 ·
30mm but a 1 3/16" worked fine and is easier to find ... I saw on a tuff country 2.5 leveling kit 22958 uses 9/16" x3"x10" semi-round u bolts
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top