Ford Power Stroke Nation banner

WOT nitrous switch

743 views 4 replies 2 participants last post by  07_powerstroke 
#1 ·
I have a zex nitrous kit and it has the activation switch built in the siloniod. I tapped into the white and red wire that comes out of the gas pedal ass And everything works but the wrench light is on the dash. I unwired the tap and the light goes off any sugestions i thought thats how i was supossed to wire it...
 
#2 ·
You have a bad connection. If I kick mine, every now and then that wrench Will come on.
 
#4 ·
Go to the zex web site. Should have the instructions. I can't remember off hand.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top