Ford Power Stroke Nation banner

clutch noise

503 views 4 replies 2 participants last post by  southbend_powerstroke 
#1 ·
so i installed southbend full ceramic clutch about 1k miles ago and i get the occasional chatter at low rpms. no big deal. i installed everything to the correct spec. now that i have some miles on it, its starting to squeal a little bit on initial take off. any thoughts?? thanks for the help guys!
 
#2 ·
I got the same thing with about 4k on it now, I asked the guys at south bend and they said it is what it is, It is made for high horse/torque. The chatter is most likely cause it is not a dampened clutch with the small pucks on the intermediate plate.
 
#3 ·
sounds good. im relieved to hear it. i just hope that i did everything right! haha i guess only time will tell....
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top