Trying to change ball joints/universals/unit bearings/hubs and ran into a snag.
Been following this link but the procedure for removal of the axles isn't working.
Going by his pics, he doesn't have the shield around the stub shaft that I do and it doesn't look like it would pass thru the knuckle (see pic below).
Should I be trying to remove the knuckle and axles together?
Been following this link but the procedure for removal of the axles isn't working.
Going by his pics, he doesn't have the shield around the stub shaft that I do and it doesn't look like it would pass thru the knuckle (see pic below).
Should I be trying to remove the knuckle and axles together?