Ford Power Stroke Nation banner

help with rubbing...

964 views 6 replies 4 participants last post by  tsanjose 
#1 ·
i just put some 20x12's w/37" toyo's on my truck (6" lift). i rub at full lock and was wondering what people are doing to help. on my other car there were ways to tuck the liner to gain some clearance. any tricks for the 08 superduties?
 
#2 ·
I'm in the same boat. You can trim the inner plastic fender, but mine still rubs. I am thinking of changing my coil springs to the 7" icon and hope that extra inch helps
 
#4 ·
yeah i was thinking about a taller spring too. but coil spacer might be another option...
 
#5 ·
Where is it rubbing? On the inner fender liner?

You can drill a couple holes in it and use tiewire to pull it back... I did that for a while.
 
#6 ·
im rubbing on the end of the flare (and inner lining next to it) near the lower door meets the rocker panel.
 
#7 ·
so looks like the dealership trimmed my inner panel afterall. they did a pretty clean job and i didnt even notice it :)

i took my dremel and trimmed it about an inch more and no more rubbing!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top