Ford Power Stroke Nation banner

drw to srw

2K views 16 replies 10 participants last post by  fifty 
#1 ·
hey guys was wanting to change my rear axle. I have a 2004 350 drw and was curious on what srw axle would be compatible with my drivetrain. Any help would be better than where i am at now
 
#4 ·
If you have the 8 bolt x 170mm hubs, then just remove the dual wheels and put on singles. In the front, remove the hub spacer. Rear is a Dana 80, which is stronger than a Sterling 10.5" . Wheels will stick out a few inches further.
 
#6 ·
yep i was jst going to say the same thing, I have put a many dually axles in srw pulling trucks. it makes the back tires like 2-4" wider but its not really noticable!

Travis
 
#7 ·
Your bed will look like crap without the dually fenders. Keep it DRW! :)
 
#8 ·
That's a pretty sweet looking dully, seen u at the auction saturday. Sharp looking truck. How many miles on the truck. Are you looking to swap stuff or what?
 
#14 ·
PM abrannan19. They did a dually with super singles. Theres a thread somewhere with pics.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top