97 f250 front axle shaft removal
Workin on my friends 97 f250 D50 TTB. Replacing the ball joints and axle u joints. Havin a hard time getting the pass axle shaft out of the spider gear. Its been a while since i worked on one of these but dont they just "pop" out w a little effort? There isn't a "c" clip that i have to pull out, right?
And also his outer axle shaft i bad due to severly worn out wheel bearings. The axle has a groove worn into it where it has been rubbing the spindle. Anyone ever run into this?
Looking for Blue 40-20-40 seat for OBS. PM me if any known